Linksys Wireless-G Access Point WAP54G ver 3.1 security problem [ Edited ]

[Siipiveikko]

Hello!

I have a new WAP54G Access point in our network. I would like to change WPA security settings, but am not able to do it.

I have done everything as installation leaflet says, and I get to the 5th point Status sheet: Firmware version v.304, MAC address (numbers), IP address 192.168.1.245, SSID linksys, Channel channel 6 and WEB security Disable

What I would like to do, is change SSID and have WPA2 security. When I am clicking "Yes", it goes to the next sheet "Password",  I write admin and click "Enter". I will have Pop-up window "Setup Access violation at address 0049BDB6 in module 'Setup.exe'. Write of address C933016A."

So please, any ideas what to do? This should not be so difficult... It works fine as access point, but I need to have at least little bit of security.

BR,

Vesa

P.S. both are physically in the same hub

[ScarletJamie · Accepted solution]

I suggest resetting the access point and manually configure it. Just access the link below for your reference.

http://www6.nohold.net/Cisco2/ukp.aspx?vw=1&docid=6579d209b91949adb3f355fceaa2296f_16627.xml&pid=80&...

[Siipiveikko]

Thank you for your help!

Solution was quite easy: Username (blank), Password admin, insteadt of instructions in installation leaflet. I appreciate your help a lot, it is nice to solve a problem which have take my time over 4 hours... I won't say what is on my mind

BR,

Vesa