Can not connect to http://192.168.1.1

[VIRBION]

Can not connect to http://192.168.1.1

[torqued]

Try 192.168.0.1

[Dudeship]

I want to make sure my Wireless Router is set to the "G" output.

[torqued]

If you have the WCG200ver2, refer to page 23 of your manual. 

When your wireless computer detects the WiFi network, it should report if it sees a "b" or a "g" network. 

[lalo padilla]

---

Ricewind wrote:

Hi.... I think you should reset the gateway for 1 min. Check the browser settings, reduce the security and privacy  on the browser. Disable all the firewalls and spywares and try again to access this setup page with http://192.168.0.1

---

i dont know my pass!!

[torqued]

"i dont know my pass!! "

It is in your manual. 

[Kimbo]

I'm using a Linksys WRT54GS-V5 and your method may be different than mine; this might be worth a look. When you open your browser (like Internet Explorer) and select a search engine (like Google) and type in 192.168.1.1, check the address window before hitting the enter button. With Google, it adds your input to theirs and you might end up with something like http://www.google.com/search?hl=en&q=192.168.1.1. This will not work. Try removing the entire address and typing in just the "http://192.168.1.1" address and then hit enter. Works in my case. Good luck.......................

[zae0203]

For those of you who cant connect... it may be because its under a secured (https) prefix. I suggest trying https://192.168.1.1 or https://192.168.0.1 - it worked for me

[longtail]

don't type the http:// just type 192.168.1.1, i almost pulled my hair out before i figured that out

(Mod note: Edited for guideline compliance. Thank you.)

Message Edited by Vince_02 on 05-03-2008 09:16 AM

[EpiquE]

longtail's right...just do the numbers.... and guys, if it brings you to a web search result thing... do this:

click "start" - "run" ; and on the run command type (http://192.168.1.1)

this'll work...