- last edited on
i have a router to connect on Internet, i need it because it let me use VOIP.
I want to use WAG120N like Access Point Wireless because my VOIP router is not wireless.
How i have to configure it?
What kind of incapsulation i have to use?
VOIP router IP: 192.168.1.1
If is it possible (and if it is useful) i would to configure WAG120N with 2 IP,
first one: 192.168.1.101 (to communicate with VOIP router and to let me go on internet)
second one: 192.168.0.1 (to let me have control on it's configuration)
My devices will connect to 192.168.0.0 network
Is it possible?
05-17-2010 09:55 AM
05-17-2010 10:04 AM
05-18-2010 07:28 AM
On your WAG120, goto Router Config Pages
Setup > Basic Setup
Change Encapsulation: Bridged Mode Only
Set Local IP Address of WAG120 to something other than your Non-wired Modem/Router and also not within your DHCP range.
Set the DHCP Server to "DHCP Relay" and input the Relay DHCP Server (typically your wired modem/router).
Please ensure that your non-wired modem has DHCP server setup
Save the settings, you're done!
05-18-2010 08:10 AM
05-18-2010 09:45 AM
There is some way to manage or aumentate the power of the antenna / range?
My home is not so big but the signal power is low between 2 rooms..... i cannot navigate, the connection always go down
06-10-2010 10:02 AM
I'm going to buy two linksys WAG120N and i wanted to know if i can use them as TWO acces points. I mean, is it possible to connect them to each other (through an ethernet cable cat5 or cat6) and then connect one of them to my internet router (internet source) with an Ethernet cable too.