Posts: 1
Registered: ‎09-28-2009

DPC2100R2 access level

I have a Webstar DPC2100R2. Cisco recently pushed out new firware updating the old Scientific Atlanta firmware. I am now unable to access the area to set my access at level 2 so I can troubleshoot. Can I get the new settings url & new pass?


the old acces info was:
pass: w2402

Posts: 3,173
Registered: ‎09-07-2006

Re: DPC2100R2 access level

The default IP address to access the setup page of the Webstar modem is and by default the Username is : admin and the Password : w2402. If its unable to access the username and password then you need to reset your Modem and re-configure all the settings on it again.