08-10-2010 10:07 AM
Hi there! Where I can see Line State in WAG 320N? Line States like Latency Type, SNR Margin US/DS, Line Attenuation US/DS, Power US/DS etc.
I have found just Downstream and Upstream Rate in Status/DSL Connection.
Sorry for my english.
Solved! Go to Solution.
08-11-2010 01:12 PM
You won't find Latency Type and SNR Margin information available on WAG320N.
To get these information you can try to install DD-WRT firmware on WAG320N, but this will void the warranty of your router.
08-12-2010 02:18 AM
You can acces information like:
via the 'hidden' page http://192.168.1.1/setup.cgi?next_file=adsl_driver.htm
were 192.168.1.1 is the ip of your router.
--- System Information ---
Firmware Version: 1.00.12 , 2010-03-22T10:51:43
Boot Version: 1.06
Hardware Version: 0.01
--- DSL Information ---
DSL Driver Version: AnnexA version - A2pB023k.d21d
DSL VPI/VCI: 8/35
DSL Status: Showtime
DSL Mode: G.DMT
DSL Upstream Rate: 512 Kbps
DSL Downstream Rate: 4640 Kbps
DSL Noise Margin: 21.9 dB 23.0 dB
DSL Attenuation: 16.0 dB 7.0 dB
DSL Transmit Power: 15.7 dBm 11.9 dBm
--- Wireless Information ---
Wireless Driver Version: 184.108.40.206.cpe4.402.4
Wireless Status: Enabled
Wireless Wide Channel: 8
Wireless Standard Channel: 6- 2,437 GHz
--- Dynamic Information ---
LAN Mac Address: 00:22:6B:*******
WAN Mac Address: 00:22:6B:******
Wireless Mac Address: 00:22:6B:******
01-16-2011 02:17 AM
Using RouterStat 6.6 (free programme) will monitor SNR, Attenuation, and power on the WAG320n - configure the page for option 1 when capturing data - and this seems to work fine.
Page for capture below - where router address is default.
What it shows is that this Box appears sensitive to line separation of the incoming DSL and perhaps USB power side? These are at opposing sides of the box (by design?). Lesson seems to be not to tidy cables in a bunch as playing a Vid on USB caused 2dB interference on SNR - moved cable 6" and the SNR increased 1dB and was very stable. Could be cause of others issues with stable connection if on the edge of target SNR profile on the DSL.
Hope this helps.