- last edited on
i want to update my old Linksys WAG200G firmware but i see that on the page:
on the Downloads tab it lists:
Ver.1.01.09 at the top with full notes, and then further down it lists Ver.1.2 with no notes. Which do i use?
Solved! Go to Solution.
12-04-2012 03:51 AM
The link below will guide you how to determine what annex is your gateway.
Title: Checking the Annex and Model Number of a Linksys ADSL gateway Article ID: 4305
01-05-2013 09:42 PM
Once done with the firmware upgrade the settings will still be the retained. Unless you will do a hard reset on the router itself, the settings then will be back to the default settings. It is recommended that after every upgrade, a reset should be done. But it’s going to be up to you if you want to proceed with the reset or not. You may the leave the settings as is but if you start to have connection problems, proceed with resetting the modem then reconfigure the settings.