Reply
WJurecki
Posts: 4
Registered: ‎06-24-2009

Beeping from NMH300

NMH300 Firmware 3.18.4, Media Browser Software 1.7.46

 

To resolve my other issue of not being able to delete a specific file (that I would consider a corrupt file) I changed to single drive mode and then back to RAID 1 (the only way I have found to reformat the drives).  During the syncing of the drives the NMH would sometimes beep.  Sometimes for a longer duration and others for very short beeps.

 

After what should have been long enough for it to sync (at 2 hours it was about 71% done and this is now at about 8 hours) I was unable to get into the configuration screen and decided to reboot the NMH to attempt to resolve the access issue.  I hit the power button till it started to flash and did actually power down a few seconds later.

 

Now, the fun!  When I turned it back on the power light has been flashing now for at least 30-45 minutes and beeping almost constantly!  I can hear some hard drive access from time to time.

 

What is this beeping indicating? and how do i stop it?

 

 

Wilkins377
Posts: 599
Registered: ‎01-08-2009

Re: Beeping from NMH300

Hi,

 

Did you try to have only 1 drive installed on your mediahub ? Would the mediahub still beep with 1 drive installed ?

 

It could be the harddrive causing the beeping sound.