Unable to Connect to Primary Wireless Network

[wayneholly]

I have been able to connect with my primary wireless network until this morning. Now I cannot connect even after running the troubleshooter. Luckily, I have a Clear 4G modem that gives me access to its network.

The only change I made was installing Panda Global Protection 2013 beta last night. When I noticed the connection problem, I uninstalled the Panda software and rebooted. No luck.

Any suggestions?

[quack]

What is the model number of the router? Try the following steps:

# Open up the browser and on the address bar type 192.168.1.1 that will open up the Router setup page.

# Then Click on wireless Tab select, Wireless Network mode “Mixed”, and make the Channel to 1, 3, 6, 9, and 11. Click Save Settings.

#Adjust the following advanced wireless settings:

~~ Lower the beacon interval from 100 to 75

~~ Lower the fragmentation threshold from 2346 to 2306

~~ Lower the RTS threshold from 2347 to 2307

Then check the status..