Problem connecting WET610N to Cisco AP1240AG [ Edited ]

[enrich]

Strange problem:  I try to connect WET610N bridge  to our WIFI network using Cisco AP1240AG, it stops working and freezes (the power LED flashes blue and pink).  I have to hard reset the unit to get back into configuration web page. 

But when I connect it to other "cheaper" AP (Linksys WAP54G or Cisco WAP200), it works perfectly.  I update the firmware to 1.0.05, try a lot of options on both AP or bridge: no use.   Both units use WEP encryption.  Any clue?  Thanks

[Corleone]

After upgrading the firmware did you reset both the devices? After successful firmware upgrade you need to reset the devices. It is recommended to reset the devices once. Steps to reset:

 Push the reset button on devices located for 30 seconds, turn off both the devices wait for 30 seconds and then power it on. Power light should blink when you perform the reset process.

After reset, reconfigure both the devices one by one and then check the connectivity status… 

[enrich]

Oh yes, a lot of time.  Just want to know if there's an option incompatible between AP1240AG and WET610N.

[Corleone]

Cisco Aironet 1240AG Series which has the standards of IEEE 802.11a/b/g where as WET610N Gaming and Video Adapter has 802.11a/b/g/n 2.4/5GHz Dual Band.

That means the only difference will be of signal strength which will be “G-Mode”.  For more information here is the link: http://www.cisco.com/en/US/prod/collateral/wireless/ps5678/ps6521/prod_qas0900aecd8031c8dc.html