Reply
GlazedHam
Posts: 1
Registered: ‎03-30-2007

Setting up LACP - Link Aggregation Control Protocol on SRW2024

I have 4 SRW2024's switches. I currently only have 1 cat6 cable running from one to the other. I am looking for help in how to setup Link Aggregation.
 
First - Should I connect swtich 1 to switch 2 and 3 or both cables to switch 2? Does it matter or is it better so if a switch was to go down I am only loosing one of the switches and not everything below it.
 
Second - What auctually do I have to do in the switch itself? Can anyone display a couple of screen shots on how to set this up?
 
Thanks :smileyhappy: