Posts: 3
Registered: ‎07-31-2006

I'm trying to configure the switch. I need a port on this switch to participate in 2 VLANs. Can somebody guide me to do it?
I do the following:

- VLAN1 and assign port 1 as untagged.
- VLAN2 and assign port 13 as untagged.
- Configure VLan port 22 as General.
- Assign port 22 to VLAN1 and VLAN2 as untagged.
- Enable VLAN1 and VLAN2.

I have a PC connected to port 22 and i cannot do pings to port 1 or 3.

Thanks in advance.

Posts: 3
Registered: ‎08-03-2006

Re: srw224p

Did You make Port 22 as Trunk Port 
Posts: 3
Registered: ‎07-31-2006

Re: srw224p

Thanks for the reply.

linksys support say that i need a compliant 802.1q ethernet card in the pc to work. I have tested it and it works.

Thanks again.