03-27-2010 03:44 PM - edited 03-27-2010 03:48 PM
Not sure if this has been addressed before...
i found this link but my setup is slightly different.
presently, I have a dry loop phone line---> speedtouch DSL modem---> D-Link DIR-601 and the LAN 1 going out 2 the main computer and LAN 2 going out 2 the SPA 2102
I can get my D-Link system working fine w/o the SPA or I can just hook up the SPA w/o the D-Link and then both phone/internet works fine.
Both have been registered separately using the 192.168...addy
but getting the Internet/VoIP/Wireless has been impossible....so far...
thx in advance,
03-28-2010 02:30 PM
Basically you're cascading 2 routers. If that is so, you're creating double NAT network. As much as possible, it is recommended to connect the SPA2102 as a primary router because Voice requires more bandwidth.
This should be your network setup: DSL Modem - to the WAN port of SPA2102 - to the WAN port of the Dlink router.
If I'm not mistaken, these 2 devices are having the same IP. Change the LAN IP of the Dlink router from 192.168.0.1 to 192.168.1.1.
03-29-2010 06:01 AM
i tried your suggestion and configuration.... not working as of yet....
I even tried reversing the LAN IP's have the SPA as 192.168.1.1 and D-Link ... 0.1
when both are plugged in the phone will work (in your configuration) but net service won't flow thru SPA 2 the D-Link and if it does then from there it gets cut off before it reaches computer.....
any other settings i might need to change? please don' assume anything as i've never set up a network like this..... thx again...
03-29-2010 07:15 AM
What IP address you're getting when computer is connected directly to the modem? Is it a modem/router?
If IP address from the modem is a private IP (e.g 192.168.1.x) then you need to call your ISP and ask them to set your modem/router to a Bridge.
I have found these articles related to your concern.