Reply
EarloftheWest
Posts: 2
Registered: ‎09-29-2008

PAP2 Not dropping the call after I hang up.

Using Future-Nine as my SIP provider. Running PAP2 with a normal phone. I've been doing a few tests on my system. I would use Future-Nine to call my cell phone. I would answer my cell phone then hang up my analog phone. The cell phone is still connected to something. Is it the ATA or Future-Nine that's holding the call? In a similar vain, I would call my cell phone using Future-Nine and then hang up on my Future-Nine phone. Apparently, the call is still going to my cell phone because it would end up receiving a voice mail (with nothing on it of course.) I'm thinking that the cell phone is still being dialed I don't answer and then it goes to voicemail. If the issue is the ATA, is there a setting I can change on the ATA so it will end the call when I hang up my telephone?
blitzjaice
Posts: 74
Registered: ‎05-03-2007

Re: PAP2 Not dropping the call after I hang up.

try to set the reorder delay on the PAP2 to 255
also change the CPC delay to 0 and the cpc duration to 1
EarloftheWest
Posts: 2
Registered: ‎09-29-2008

Re: PAP2 Not dropping the call after I hang up.

[ Edited ]
Thanks for the suggestion. It didn't seem to help so I went ahead and reset the router and that appears to do the trick - after 2 tests anyway. :smileyhappy:

Message Edited by EarloftheWest on 09-30-2008 03:52 PM