04-26-2009 07:59 AM
Setup: Actiontec 704(qwest) as primary - does firewall & dhcp. A WRTU54G-TM on net - does the @Home/cellphones and wireless point. Somehow it changed it's local IP to 24.1 and I can't get it back to 0.1 It dhcp's and get GW of 0.10. The @Home connects fine. My network is 0.0 and I can't connect to the Linksys router web page. I've done the hold reset 30sec power off - several times - always goes to 24.1 for local IP.
04-27-2009 03:41 PM
Hard reset your router for 1 minute...
Press and hold the reset button for 1 minute...Release the reset button...Unplug the power cable from your router, wait for 1 minute and re-connect the power cable...It should reset your router to 192.168.0.1...username and password both admin...
04-29-2009 08:13 AM
Here is what I found. I have the orig router on the 192.168.0.net. Then the WRTU54G CD T@Home software scans the network and finds the orig router on the 0.net it sets its self to 24.net - IF it is set to "Router" - if you set it to "Bridge" it will allow you to set it to DHCP (getting IP from orig) and allows you to set the "Local IP" to 192.168.0.whateveryouwant :-)
So, I ran the setup - ended up with 192.168.24.1 (and it set the MS windows box to 24.65 (I think). Then I Web'ed in and set it to "Bridge" - "Save" - set LocalIP 0.11 - "Save" - and life is good.
And that's the way it's going to stay. If I could "telnet" in and load "my" iptables then I might make it the primary router on the net. But because someone had ruled that is not allowed ....