You will need to first find the IP address of your device and then enable HTTP configuration. To do so have a pen and paper ready to write down the IP address. Once you're ready do the following:
Pick up you telephone handset
Dial ****, do this even if you hear a busy signal
You will hear a message - "Linksys configuration menu. Please enter option followed by the pound key...", then enter 1 1 0 # on your phone.
You will now hear a message giving you the IP address of your device such as - "192.168.001.100". Write this number down
Do not hang up yet. As now you will need to enable web-based configuration, since by default the web-based configuration for the WAN port is disabled. To enable web-based configuration:
You will hear the menu prompt again after acquiring the IP address.
After hearing the prompt dial 7932# followed by 1# then 1 when asked to save the change.
You should now have the IP address for your SPA3102 as well as the ability to configure your device through your web browser.
Hope this helps.
