06-16-2012 05:36 PM
I'm considering purchasing the "Cisco Linksys - E1200 Wireless-N Router with 4-Port Ethernet Switch". Before I do, however, I want to know how to configure it as a wireless bridge to my existing wireless network.
I have a hardware device with only an ethernet connection (no wireless option avaialble). I want to connect the device to a wireless router / access point, in this case it would be the e1200, and then connect to my existing wireless network. The e1200 would be acting like a client of the existing network.
I found this article but Step 8 is causing concern. I do not want a wired connection. The two routers must connect wirelessly.
Title: Setting up your Linksys Wireless-N router on Bridge Mode
Article ID: 24583
06-17-2012 12:22 AM
The router is not design to act as an Wireless ethernet bridge,wireless repeater or an access point client. You need to load a tird party firmware for that to happen.
06-17-2012 02:46 PM
There are two (2) ways to connect a Linksys router to another router/modem:
1. LAN to LAN – Connecting one of the Ethernet ports (LAN ports) of the Linksys router (router A) to one of the Ethernet ports (LAN ports) of another router (router B).
This type of cascading requires the main and the secondary router to be on the same LAN IP segment to allow the computers and other devices to connect to both routers. This configuration is recommended if you want to share files and resources within the network.
2. LAN to WAN – Connecting one of the Ethernet ports (LAN ports) of router A to the Internet port (WAN port) of router B.
This type of cascading requires the main router and the secondary router to have different IP addresses. This connection makes it easier to identify which router the computers and other devices in the network are connected to since they will have different LAN IP segments. However, computers that are connected to router A will not be able to communicate with router B, and vice versa since they are two different networks.
06-24-2012 10:53 PM
here's an article related to your bridge setup: Setting up your Linksys Wireless-N router on Bridge Mode
Please read before posting!!
The E1200 cannot be configured as wireless bridge!
The bridge mode you can configure is for wired bridging. It bridges the WAN and LAN ports. That's it.
The E1200 won't operate as wireless bridge. It won't connect through wireless to another access point.
Please read the thread before posting! It's has been mentioned multiple times that it does not support wireless bridging.
06-25-2012 01:11 AM
hi gv, if you read in the article, E1200 v2 i included in the list.
If you read the article you'll notice that it's about wired connections. Not about a wireless bridge.
The bridge mode in the article has nothing to do with a "wireless bridge".
As I wrote before:
bridge mode bridges WAN and LAN ports. If you want it's a "wired bridge".
A wireless bridge bridges two wired segments through a wireless link. That's something completely different and not covered by that article or any other article because it's not supported.
I can only repeat: Please, please, please read before posting and understand what it's about.
Only because it's called "bridge" in both cases doesn't mean it's the same thing.
08-21-2017 04:37 AM - edited 08-21-2017 04:38 AM
I found ths old thread which has not clearified anything.
I have a Linksys EA2700 as main router.
I want to put another router on the other floor of the building to extend Ethernet and Wireless.
I want to buy E1200 to act in Bridge mode. (and connect to EA2700 with ethernet cable)
As I understand it will delegate everything about Ethernet addresses to main EA2700 router.
And it will make another Wireless connection of its own (it's fine by me), which would get the addresses from the ES2700 main router.
Would it work this way?