10-18-2011 11:19 PM - edited 10-18-2011 11:38 PM
I've DMZ'd my computer using the the E1200's Web Browser Config screen (192.168.1.1) yet when I try to test the ports not a single one is open.
I've used this test to see if they were open:
And almost none of them were. Is there any issue that could be causing this?
Also when I try to open a single port the site says it times out.
Opening single ports didn't help either.
I've also tried to DMZ via the IP and the MAC address of my PC and still no luck.
10-19-2011 01:30 PM
I'm not really sure what I'm supposed to be looking for on the Status page but I don't see any IP Adresses that match up with the one on whatismyip. Am I supposed to type in my computer's actual IP address (108.200.etc.etc) to open the ports or the IP that the router gives my computer (192.168.etc.etc)? I've even tried DMZing my computer using the MAC address and that still didn't help.
10-20-2011 01:42 AM
10-20-2011 11:01 PM
My computer's IP on the router is 192.168.1.118 currently. It changes every so often but I have the DMZ set to my PC's MAC address. This router is connected to only a modem but I need to see if the modem is blocking any ports as well. I don't remember seeing anything about it. I'll let you know in an update.
10-21-2011 06:01 AM - edited 10-21-2011 06:02 AM
Sorry, my fault. Status not setup...
What do you see on the Status page?
Compare demo ui: http://ui.linksys.com/files/E1200/1.0.00/Status_Router.html
10-22-2011 12:07 AM