E4200 V2 - Firmware - 2.0.37.131676

[gehx]

I have the E4200 V2 and there's a fw update available:

2.0.37.131676

i searched this forum, cisco's site and googled it and I turn up no info on this firmware.  Has anyone updated to this firmware?  anyone know what cisco' changed?  I'm reluctant to upgrade til i know what issue's/new features are addressed in this new firmware.

thanks.

[Tangerine9012]

Where did you see this?  I just checked the site and it is only showing v2.0.36 (Build 126507).

[Juggler777]

I just did a check through the router and am seeing the Available Upgrade: 2.0.37.131676. I'd prefer to d/load and upgrade manually though.

[Juggler777]

I just updated via the router and it went through smoothly. The only odd thing now is that when I check for updates it says there's a new version available - 2.0.34.126381. 

[widmark]

I just updated minutes ago.  I haven't gone deep into it but it looks like this is the long overdue update to allow WPS to be disabled.

[brandonmarkb]

Just updated as well, and I agree, it looks like this allows for the disabling of WPS.

Note that you have to first go into your wireless settings, choose the "Wi-fi Protected Setup" radio button before you'll see the "disable" button. Choose disable, then since there wasn't a "save settings" button on that screen I re-selected the manual settings (where you choose your wifi password, etc) and then clicked "save settings"

After that I could go in and verify (using the inital steps above) that the WPS was still disabled (also said so in the statuses on that page).

[lbrunelle2]

I updated to 2.0.37 and with the WPS funciton on the router set to Manual, I was still able to connect a device to my V2 using WPS.

I didnt see a disable button, so I'll run through this again as suggested by brandonmark

Also, I noticed an update to the Cisco Connect Express app on my iPhone as well from 1.1 to 1.2 

Cisco Connect 1.2 update includes:
Added support for EA2700, EA3500, EA4500 and E4200 V2
French Language support
Changed short name to "Express"
Fixed a problem when canceling from adding a device to via WPS

[rskunath]

I'd sure like to see a changelog for this update.

I see the firmware is not yet posted for manual install. 

[lbrunelle2]

I chatted and called into Cisco cusotmer support a few times today already.  They don't have any information/release notes for 2.0.37 yet either.

[lbrunelle2]

@brandonmark

Thanks!  I now see the disable button.