E4200v2 Firmware Version: 2.0.37

[lbrunelle2]

@brandomarkb.  Thank you. 

Interesting.  I dont seem to have any of these settings on my UI.  Under the wiresless tab I do not have the "Advanced Wireless Settings" submenu at all.  I am using v 2.0.37.  Is there something else I need to configure to gain access to Advanced Wireless Settings?

[brandonmarkb]

You don't need to configure anything, but you do need to go to a special URL to access them. This is the same for the v1 I believe. Just enter the URL of your management interface and add "/Wireless_Advanced.asp". So for example "https://192.168.1.1/Wireless_Advanced.asp". For some reason they hid it in the e4200 line.

[lbrunelle2]

Thank you. This is an interesting surprise. I've seen mention of this a couple of times in the forums but didn't know how to get to it.  Makes me wonder what else I dont know about this routher

[counsil]

There's also:

https://192.168.1.1/System.asp

[aise]

System.asp is visible only in v1.

[lbrunelle2]

Hello.  I tried 192.168.1.1/System.asp but confirmed I couldn't connect on my V2.  Now what to do with the /Wireless_Advanced.asp page?  In my case probably best to leave as is since I haven't yet experienced any significant bugs, or operational issues with my V2. 

However, would be nice to know if there is anything else I can do to increase 5Ghz range a bit.  Other than: using N-only, WPA2 Personal, 40 Mhz Only and experimenting with the different channels.  I wonder if there is some 5GHz setting on this /Wireless_Advanced.asp page that I may be able to tweak.  

[ToAsTyWoAsTy]

---

brandonmarkb wrote:

@lbrunelle2--Here you go, the 2.4 didn't fit in my screencap, but its parameters are the exact same as the 5:

---

I do not have these "advanced wireless settings" after updating to 2.0.37.131047...

[aise]

http://192.168.1.1/Wireless_Advanced.asp

or

https://192.168.1.1/Wireless_Advanced.asp

if you have HTTPS enabled (default IP).

[ToAsTyWoAsTy]

Oppps I did not read the entire thread. Sorry.

Your prior post anwsered my question. Thanks again.

[john.k.bracey@gmail.com]

so, are there release notes for this firmware yet?  I haven't been able to find any yet.