10-19-2011 05:57 PM
So I just noticed on my Cable modem the link light is blinking orange, per Motorola if its blinking orange - Computer is connected via a 10 mbps or 100 mbps Ethernet port.
On the Linksys E4200 status page it says
Internet Port Speed:
Internet 10/100 mbps
Local Port Speed Port 1 - 1Gbps
Maybe I just noticed this with this router, but I'm pretty sure this didn't start happening until I updated to 1.0.03.
Previously the link light was blue indicating a 1Gbps connection.
Solved! Go to Solution.
10-20-2011 01:14 PM
My E4200 shows 1Gb/sec speed for the "Internet" port, and I'm also using 1.0.03 firmware. Did you do a factory reset and power-cycle after upgrading to 1.0.03 firmware? If you didn't, you just press the "reset" button on the back for about 30 seconds then release it. Then pull the power cord for about 30 seconds and then plug it back in. After doing the "reset" you'll have to reconfigure your router, since that puts all your settings back to factory defaults.
10-20-2011 04:26 PM
Let me know that after upgrading the firmware you have reset the router or not. After updating the router it is recommended to reset the router.
Steps to reset the router:
Push the reset button on router for 30 seconds, turn off the router wait for 30 seconds and then power it on. After this process reconfigure the router. Power light should blink when you perform the reset process.
Here is the links for configuring the router according to the Cable Connection setup:
So after the router configuration check the light status as well as the speed of the router.
10-20-2011 05:11 PM
10-22-2011 09:22 AM
Looks like reseting the router to factory defaults fixed the issue, not sure how it ended up going to 10/100 with the firmware update, but its working now. Thanks