03-20-2012 12:51 PM
03-21-2012 05:11 PM
You can try the following combination of settings:-
A] With the help of Cisco Connect Software (if at all you have installed the router with the help of this software)
1] Open the software and go to the option which says "Router Settings"
2] Then click on the option which says "Advanced Settings" which will take you to the router's configuration page.
3] Then go to the Wireless tab, keep network mode as mixed,
For Channel Settings of 2.4 GHz you can make Channel Width to 20 MHz only and Channel to 6, 9, 11..
For Channel Settings of 5 GHz you can make Channel Width to 20 MHz only and Channel to 40 or 161...
4] Lower the MTU (Maximum Transmission Unit) from 1500 to 1400 or less (usually found on your router's main/ basic setup page)
B] If you haven't installed Cisco Connect then you can log on to the router's user interface using it's default IP address in the browser which is 192.168.1.1 and type in 'admin' as the password leaving the user name field blank. This will take you to the router's web interface and then follow steps as mentioned above to make the changes.
04-30-2012 03:16 PM
Could be that the router is deffective . You can call Cisco for that to check if it's really deffective or they can do something else regarding the issue
04-30-2012 09:08 PM
try reseting the router - not with the reset button but through the Administration page. also check if the ethernet cable connecting the router to the modem is good.
05-01-2012 08:38 AM
Mine does that as well. In addition, my internet signal when running thru the router oscillates rapidly between 0.5 Mbps and 3 Mbps and pings Speedtest at between 400 and 500 ms. When I bypass the router I get a constant, fast connection with a ping of 50-60 ms. Firmware is up to date and relocating the router did not solve the problem. If I can't find a solution on this forum I'm trashing it and going with an Airport.
05-04-2012 04:17 PM
Wireless devices have limitations when it comes to their signal rangeIf your wireless network devices are too far from each other, consider relocating the devices. One important thing to remember is that distance is directly proportional to signal strength. The farther you are from the Access Point, the weaker the signal.
Here is the link which can help you in resolving the issue:
05-05-2012 12:37 AM