08-16-2006 08:22 PM
08-16-2006 08:49 PM
08-19-2006 01:26 PM
08-19-2006 03:32 PM
06-12-2010 08:33 AM
Ok, you are not going to believe this, but I was having the same problem and now it is fixed!
First, I am no hardware guru, so for those of you who find my fix to be common sense, at least cut me some slack for trying every possible soultion :-)
First, I bought this Linksys model to replace MY EXISTING router, which I think is the W065 or something, a very good G model.
So when I hooked up the E3000, I did what evey lazy gamer does who's in a hurry.....I USED THE OLD, ALREADY CONNECTED, POWER CORD!!
Apparently, this old power cord does not provide enough power or something, because the router simply kept getting stuck in diagnostic mode (flashing power LED). it would occasionally stabalize, but only to eventually (usually inside of 5 minutes) reverting back to Diag mode and loosing all connectivity.
MORAL OF THE STORY: ONLY USE THE POWER CORD THAT SHIPPED WITH THE E3000!!
Hope this helps someone, cuz it drove me insane!!
05-17-2016 11:10 AM
Had a power failure. Got fast blinking power LED and could not reset. Swapped power adapter with another 12V/1A and it's working. Thanks for the suggestion.