Reply
codyp
Posts: 2
Registered: ‎03-09-2008

Rename Wireless Network

Can someone tell me how to change the name of my wireless network?   I tried the instructions on a previous post but 192.168.1.1 cannot be connected to.  I have a
BEFW11s4 V4  Linksys Wireless Router.
toomanydonuts
Posts: 6,365
Registered: ‎09-16-2006

Re: Rename Wireless Network

[ Edited ]
To view the router's web pages:

Use Internet Explorer, it usually works.
JavaScript must be enabled.
Use a computer that is wired to the router.
In the non-working computer, temporarily turn off your software firewall.

If you are using Zone Alarm, right click on the ZA icon in the system tray (lower right corner of screen) and then click "Shutdown ZoneAlarm", and see if this fixes your problem. If this does not work, try the following with Zone Alarm: Open the ZAISS control center, go to Privacy, then temporarily turn off Ad Blocking and Cookie Control, and see if that fixes your problem.

If you are using Noton Internet Security with the Add-on Pack, be sure to turn off the Pop-up Blocker. Some users have reported that they needed to uninstall the entire Norton Add-on Pack.

If you cannot get anything at 192.168.1.1 then perhaps this is not your router's address. Go to "Start" > All Programs > Accessories > Command Prompt.
A black DOS box will appear. Type in "ipconfig" (with no quotes), then hit the Enter key. Look at the "Default Gateway". Is it 192.168.1.1 ? Point your browser to the "Default Gateway", then login to your router.

If the above fails, disconnect your modem from the router, and try again. If this corrects your problem, then most likely you have a "modem-router" rather than an ordinary modem. Check to see if your "modem-router" is using the same 192.168.1.x address space as your Linksys router. If it is, then report back with this problem, and also state the make and model of your modem-router.

If all of the above fails, power down your entire system, unplug it from the wall, wait one minute, then power up and try again.

If all of the above tips fail, then reset the router to factory defaults: Power down the router and disconnect all wires from it. Wait one minute. Power up the router, allow it to fully boot (1-2 minutes), then press and hold the reset button for 30 seconds, then release the button and allow the router to reset and reboot ( 2-3 minutes). Power down router. Wait one minute. Connect one computer, by wire, to a LAN port on the router. Boot up system. It should work.

If the reset does not fix your system, then you need to download and install (or re-install) the latest firmware for your router. After the firmware upgrade, you must reset the router to factory defaults, then setup the router again from scratch. If you saved a router configuration file, DO NOT use it.
 
*************************
 
After you manage to login to your router, go to the "Wireless" tab, "Basic Wireless Settings" subtab, and change the "Wireless Network Name - SSID" to a unique name  (do not use "linksys" ).  The SSID is the name of your wireless network, and it is the name that will appear on your computer when to go to login to your router.


Message Edited by toomanydonuts on 03-10-2008 01:25 AM
Klatch
Posts: 2,829
Registered: ‎09-07-2006

Re: Rename Wireless Network

From ant wired computer .... access router setup page using http://192.168.1.1 .... leave username blank & in password use admin .... Click on the Wireless tab on the Setup page- Here Wireless Network mode should be mixed- Provide any non-linksys name in the Wireless Network Name (SSID) box....click save settings ...
codyp
Posts: 2
Registered: ‎03-09-2008

Re: Rename Wireless Network

Thanks for the info.  I figured it out after I posted by reading some of the other posts.  It was simple.  I just had to go to 192.2.1 log in and change it.  Better than paying 32.00 for tech support assistance.