09-16-2009 03:04 AM
My router stopped working yesterday. I suddenly had no internet connection, and I initially thought it was due to my internet provider. So I contacted them and after some tests, I connected my cable modem to the ethernet adapter of my PC, restarted the modem, and the internet connection was restored. So, the problem was in my router.
I'm trying again to connect the router (cable modem --> router ---> ethernet card in my pc) but it doesn't work.
I also uninstalled my firewall in case it was somewhat blocking the router, and updated its firmware to the last version. But still, it doesn'taccess the internet. I can access the router configuration via http protocol as usual but I have no idea what else to do.
Could you please give me a hand?
09-16-2009 07:42 AM
Advise you to reset router by pressing reset button at the back of router for 30s-1m while it's powered on, after that reconfigure router again with default username/password. I faced this problem before, and router reconfiguration solved the problem. If you need more helps, can take a look on this wireless router configuration article. Hope it helps.
09-17-2009 10:51 AM
Have you tried resetting the router after upgrading the firmware not then, Press and hold the reset button for 30 seconds...Release the reset button..Unplug the power cable from your router, wait for 30 seconds and reconnect the power cable..Now reconfigure your router...
Go to Setup Page of Linksys and Under setup tab, Click on Mac Address Clone,Check enable and click on "Clone Your PC's Mac " and Click on Save setting.Now turnoff computer,router and the cable modem....wait for 1 minute and turn-on the modem,wait for 2 minute and then turn ON the router and restart the computer..It should work now !!!!
09-17-2009 05:06 PM
Thanks both of you for your replies! I will try your solutions. But before that I have to say that I have no idea whereabouts the setup CD of my router is after 2-3 years having my router. I'm not sure if I will need the default key/password after resetting it and if it's stored in that CD, so I'm a little afraid to do it before asking.
09-25-2009 08:32 PM
After resetting router, you don't need install CD of the router in order to re-configure it, you can configure it manually. If you need moer ideas, can have a look on this WRT54G wireless router configuration help.
Linksys router --> default username: (leave it blank) password:admin
Hope able to help you..
03-27-2016 04:27 PM
lease check all connection, you have made them correct. your modem should be connected to the router properly and then do power cycle of your router. if your router is still not working then you need to factory restore your router and reconfigure it for more help visit http://www.linksys.com/us/c/wireless-routers/ . i hope this help