06-17-2007 06:41 AM
06-18-2007 02:31 PM
05-26-2012 08:09 PM
I have one router that is connected to my P.C and it,s a WRT54GS2 V1 and my daughter Laptop is connected to this router and the only way it is running now unless the ethernet cord is connect to the router I had the Cd but can,t find it will you help please.
05-26-2012 11:08 PM
Hi Johnny Shaw, this link will help you access the router page http://www6.nohold.net/Cisco2/ukp.aspx?pid=80&vw=1&articleid=3698. After you configure the wireless settings of this router, just open this link http://www6.nohold.net/Cisco2/ukp.aspx?vw=1&docid=32036bdcd9dd44ec94f94fc5f6da666f_Connecting_wirele... this will give you directions on how to connect the wireless computer to the network.
07-15-2013 08:46 PM
Help. I just replaced my modem with a new one (D-Link-5208) and now my WRT54G linksys wireless router does not work. I don'h have the original CD. How do I adjust the router to the new modem? This stuff is just about beyond me. Thanks, Dan
07-15-2013 11:23 PM
What is the ip address of your new modem? Connect a computer to it and open a command prompt and do ipconfig. If the ip address starts with 192.168.1.xxx then there is a possible ip address conflict. What you need to do is change the router's address so that you will be able to use the router with your new modem.
Open the link below and follow the steps about "Cascading the Linksys router to another router
07-16-2013 11:58 AM
Thanks for answering. The modem has the same address as the router 192.168.1.1 I managed to get in there once and changed the last digit to a 2 but it didn't fix the problem. I did not disable the DHCP server. Should I have?
Now I can't seem to get back in there at all. I tried to use both 1 and 2 as a last digit but can't come up with the setup page again. When I try to go to the set up page, the modem needs to be connected to the router, correct? The instructions don't explicitly say to but they tell you to launch a brouser. The trouble is there is no internet connection because the router doesn't let it through. I can't figure out what I did the one time I did get in.
I tried to call Linksys but they want money to tell me how to fix this problem. Any help you can provide would be greatly appreciated. Thanks loads, Dan
07-16-2013 12:08 PM - edited 07-16-2013 12:08 PM
Disconnect the router completely and verify your modem IP address. Let's assume it is 192.168.1.1. Now connect just your computer to the router, nothing else and set the IP to 192.168.1.2.
You may have to connect to the router at 192.168.1.1 first and then change the IP. Now go back and connect the two. Power on modem first, wait 2 mins. Power on router and check your settings.