Reply
walepiper
Posts: 2
Registered: ‎12-07-2010

VPN Config on WRVS4400N

Good day,

I am new to VPN configuration but i am presently configuring a site-site VPN connection to a network provider using Cisco LinkSys WRVS4400N. I configured the VPN Gateway Peer as our Internet Public IP and the host IPs as our private LAN IPs 192.168.1.0/24. I realised the VPN connection is not coming up.

 

Here is the network diagram:

 

Here is the config page:

 

 

vpnconfig1.jpg

 

On trying to connect the VPN, below is the log:

 

 

Dec 23 10:26:30 - [VPN Log]: "XXX" #3: initiating Aggressive Mode #3, connection "XXX"
Dec 23 10:26:30 - [VPN Log]: "XXX" #3: message ignored because it contains an unknown or unexpected payload type (ISAKMP_NEXT_NAT-D) at the outermost level
Dec 23 10:26:30 - [VPN Log]: "XXX" #3: sending notification INVALID_PAYLOAD_TYPE to 41.220.79.242:500
Dec 23 10:26:32 - [VPN Log]: "XXX" #3: message ignored because it contains an unknown or unexpected payload type (ISAKMP_NEXT_NAT-D) at the outermost level
Dec 23 10:26:32 - [VPN Log]: "XXX" #3: sending notification INVALID_PAYLOAD_TYPE to 41.220.79.242:500
Dec 23 10:27:40 - [VPN Log]: "XXX" #3: max number of retransmissions (2) reached STATE_AGGR_I1 

 

Expert
daikunzeon
Posts: 381
Registered: ‎10-01-2006

Re: VPN Config on WRVS4400N

These products are being handled by the Cisco Small Business Support Community. (URL: https://supportforums.cisco.com/community/netpro/small-business)