06-15-2011 11:57 PM
I use IE7.0
user name : admin
password : admin
Error is saying "401 Authorization required" Browser not authentication-capable or authentication failed.
also got the upper error message when using
user name : (blank)
password : admin
Please tell me how to do it?
06-16-2011 12:03 AM - edited 06-16-2011 12:05 AM
First, try using a different browser. If it still doesn't work, password most likely has been changed. To get back in, you will either have to remember the correct password or reset the router. To do that, get a paper clip and hold the reset button for 30 seconds. You should be able to get back in the setup page. You're going to lose your current settings so just configure from scratch.
06-16-2011 01:00 AM - edited 06-16-2011 01:01 AM
still cannot access the setup page I try the IE and Safarie
The Power Led keeping flash , is the hardware problem
I also try to hold the reset button to 30seconds and unplug the power and puug again
06-16-2011 11:38 AM
Reset the router for 30 seconds
reconfigure your router once again.
because you are not able to open the set up page with the default user name and password.
while reconfiguring the router do not set the password for the router.
you can set the password for the wireless.
06-16-2011 07:51 PM
Does the Power LED just keep on flashing? Or are you just stuck on the login page?
If you can't access the setup page at all, try downloading the latest firmware then following the instructions on this link.
06-16-2011 10:22 PM - edited 06-16-2011 10:24 PM
But canot access the setup page
How can I setup the wireless password , Please tell me how to do it .
Also if download the lastest firmware , How can I upgrade it .
06-16-2011 10:35 PM
To install the latest firmware, you need to get into the setup page. But since you can't get there, do the 30-30-30 reset trick:
That should get you into Management Firmware Update mode. Just browse for the firmware file from there and follow the onscreen instructions to perform the upgrade. Once you're done, reset the router then powercycle.
Once you're done, that should let you go into the setup page with "admin" as username and password. Just go to Wireless > Wireless Security to change your wireless password.