11-26-2008 02:03 PM - edited 11-26-2008 02:04 PM
I have 2 WAP200E APs. I want to connect two buildings. I know I need to set the APs up in bridge mode, but I'm not sure where to start.
Currently I have both in bridge mode, with PKS2 security set and the SSID broadcast off. On each unit, I have the opposite unit's MAC address entered in the bridge mode section. No joy. No connection.
Do both have to be in bridge mode?
How can I see the connection status?
What do I need to do to get these working properly?
Solved! Go to Solution.
11-29-2008 09:39 AM
12-01-2008 07:59 AM
04-23-2009 08:37 PM
A common mistake in not getting bridge mode to work is using the LAN MAC address instead of the wireless MAC address. Here is a link showing graphically the difference.
06-25-2009 02:53 PM
Hi, i have the same problem, and i am using wireless mac address. I configure the same SSID and wireless channel in APs.
I am testing APs in lab, before put it in definitive locations.
I follow manual an Help instruccions, but the APs could not connect each other.
I test it in Acces Point mode and APs works well. Somebody know what the problem is ?