Reply
Posts: 3
Registered: ‎02-07-2009

WRT610N - New Firmware 1.00.02 B10 questions

I just installed the new firmware on the router, but I cannot access the Twonky configuration page any more. The http://192.168.1.1:9000/ doesn't seem to work any more. Any help please??
Posts: 1
Registered: ‎02-06-2009

Re: WRT610N - New Firmware 1.00.02 B10 questions

Maybe rather than trying to login on a specific port, you should use plain old http://192.168.1.1 ?  Worth a try, I don't know anything about your specific situation...
Posts: 3
Registered: ‎02-07-2009

Re: WRT610N - New Firmware 1.00.02 B10 questions

I can access the router's GUI interface. The problem is that I cannot access the twonky server config page.
Posts: 3,636
Registered: ‎09-07-2006

Re: WRT610N - New Firmware 1.00.02 B10 questions

Once the Upgrade is done press and hold the reset button for 30 seconds...Release the reset button...Unplug the power cable from your router, wait for 30 seconds and re-connect the power cable...Now re-configure your router...

First Check the Physical Connections.... Modem - Internt Port on Router and then Port No.1 on Router to your Computer... then Click on Start - Run - CMD and type "ipconfig" and check the Default Gateway and try to login to your Router with that Gateway Address. 

Highlighted
Posts: 3
Registered: ‎02-07-2009

Re: WRT610N - New Firmware 1.00.02 B10 questions


Mort wrote:

Once the Upgrade is done press and hold the reset button for 30 seconds...Release the reset button...Unplug the power cable from your router, wait for 30 seconds and re-connect the power cable...Now re-configure your router...

First Check the Physical Connections.... Modem - Internt Port on Router and then Port No.1 on Router to your Computer... then Click on Start - Run - CMD and type "ipconfig" and check the Default Gateway and try to login to your Router with that Gateway Address. 


 

First of all thank you foe the reply. I have done all the above before. I HAVE NO PROBLEM TO LOGIN to the router, or to access the routers config page. The problem is that I cannot access the TWONKY CONFIG page which used to open at the ROUTERIP:9000(port), in my case 192.168.1.1:9000. On that page with the previews firmware you could configure the media server soft which is aleardy installed in the wrt610n firmware. I do not know if I made myshelf undrestood.
Posts: 1
Registered: ‎03-15-2009

Re: WRT610N - New Firmware 1.00.02 B10 questions

It appears that this problem affects all users who upgrade to the new firmware. Prior to the upgrade, pointing your web browser to port 9000 of the router's IP address would give you the twonkyMedia admin page, now you get a message that says "/index was not found on this server".  It looks like there is a web server still alive on that port, but it's not able to find the pages to serve up.

 

There are at least four other users reporting the issue on the TwonkyMedia forum:

http://www.twonkyforum.com/viewtopic.php?f=4&t=6137&p=22821#p22821