04-15-2011 12:46 PM
Hi, I've had to reinstall my wrt110 router. All is well, as for as the installation, it stated it was loaded successfully.
I feel rather embarrassed to asked this question, but I think that the installation is for the mini type tower computer and I have a laptop.
So when my laptop is standing alone- which is a HP, running Windows Ultimate- it doesn't pick up the signal from the router.
My high speed line is through Telmex, Mexico's leading distributor,
The line goes through Infinitum then to my laptop or router.
I've use this router for a year, on my other laptop, which was stolen this week here in Reynosa Mk., someone broke into the mission house here.
Now I have a very good used HP, and like I've said above,00 I've loaded and completed the installation, yet, when I disconnect there's no signal pickup.
Well I hope this make sense to someone.
04-16-2011 08:01 AM
Try to reset the router and reconfigure it manually .
Connect the computer with the Ethernet cable to the Ethernet port of your router and make sure the Internet is connected to the router .
Press and Hold the reset at the back of the router for 30 seconds .
Power cycle the router and modem .
Open the setup page of the router using the IP Address 192.168.1.1 ( User name=blank , Password= ' admin ' ) .
Configure the settings on your router manually .
Also you can follow this link for Cable Internet Service provider .
For DSL Internet Service Provider follow this link .