06-25-2011 04:53 AM
my cable company swapped out my modem yesterday from a toshiba to a cisco 2100. prior to this new modem, my router/modem combo worked fine. now my router will not obtain an ip from the modem and ive tried everything to get it to work. my internet works fine when the modem is plugged directly into the computer. i am on the latest firmware version 8.00.8 for this router. when i originally updated the firmware it worked fine, but then when i power cycled everything it stopped working again. can anyone point me in the right direction to get this working again? heres some things ive tried to reslove the issue:
update firmware - worked well until i powered off the device
clone pc mac addres
reset to default
again, any help or suggestions would be a lifesaver! thanks
06-25-2011 08:25 AM
So when you powercycled, did you unplug everything first for 30seconds. Next did you plug in the modem first and did you wait for it to boot up before you connected the router. Have you made sure that DHCP has been enabled?
If you did that then try using dhcp release and then dhcp renew @192.168.1.1. If that doesn't work then you can try pressing your reset button. And if all those don't work then your only choice might have to be a factory default. You can do that in the admin page @192.168.1.1 or you can hold the reset button for 30seconds. It will erase all your settings.
06-25-2011 10:14 AM
yeah i have pretty much tried all that. one thing i noticed was different after the firmware upgrade is that the big light on the front of the router that was normally orange is now a blue-ish color. does this indicate something is wrong with the router?
06-25-2011 10:44 AM
06-25-2011 11:15 AM
i have time warner cable and yes i can access the router ip. you asked about connecting a wireless device...not sure if i understand what youre asking. on the back of the router i am using 3 ports; xbox, blu ray player, and upstairs computer; only 2 devices in my house use internet wirelessly; my computer downstairs and my ps3. the computer that the modem and router are hooked up to is not wireless. anything else, please ask...im determined to get this working since neither twc or linksys will help me
06-25-2011 12:10 PM
06-25-2011 04:53 PM
ok, so heres the weird thing...i get home from work today power cycle again and now its working. before i left for work this morning i power cycled, nada. had my wife check when i was at work, nada. did nothing different from what ive been doing and now it suddenly works. i did manage to grab the ip, sub mask, def gateway and 2 dns address' from the status page this time which previously only showed me zeroes. im not convinced its totally working, because it did this same thing yesterday. so now that i have this new information, is it possible to manually force these address' using static ip instead of automatic configuration?
06-25-2011 05:10 PM