12-26-2013 11:10 AM
12-27-2013 01:53 PM - edited 12-27-2013 01:54 PM
Hi zx504, I have read the thread. You mentioned that you wanna use this to extend the wireless signal to an area that receives no signal from the router which is E4200 v1, right? Is this how your network looks like?
This area that doesn't have wifi, how far is it from the router? The Access Point mode is the default setting of the Linksys WAP300N.
12-27-2013 09:34 PM
01-21-2014 04:48 AM
As long as the WAP300N is wired to the router, it should obtain an IP address from it. The thing that you need to configure correctly is the wireless part since it has 4 types of Operation Mode.
01-23-2014 03:59 PM
Hi miorsaifulnizam1983, if you want to set it as an Access Point then follow this link: http://kb.linksys.com/Linksys/ukp.aspx?vw=1&docid=6318eaaff2ef4b3cb7fd6050b9898754_Setting_the_WAP30...
Title: Setting the WAP300N to Access Point mode
Article ID: 28158
For the wireless settings you may click on the "Wireless" tab. It is selectable dual band, it can operate in either 2.4 GHz or 5.0 GHz radio bands.
For the initial setup make sure that it is near the router.