12-08-2010 04:30 PM
I've got a WAP54G ver 3.1, It was working fine and one morning, it just stopped!.
The power light and link light are on all the time, but aren't ever blinking.
The orange cisco light goes on after a while.
Cant' ping it or even detect it...
What should I do?
12-09-2010 12:44 PM
Connect the computer to WAP54G with the Ethernet cable.
Press and hold the reset button on the WAP for 30 seconds. Release the reset button and wait for 30 seconds. Power cycle the WAP54G.
Open network connections on your computer. Right click on Local area connection and go to properties. Select internet protocol V4 TCP/IP and click on Properties. Select ' Use the following IP address'. Change the IP address to 192.168.1.10, subnet mask to 255.255.255.0 and default gateway to 192.168.1.245. Click OK.
Open Internet browser and in the address bar type the number 192.168.1.245. It will open the setup page of WAP54G. Log in to the setup page. The default password of WAP54G is admin.
Change the settings o WAP manually.
Once you are done with the settings, Change the IP address on your computer to Automatic.
12-21-2017 09:21 PM