Reply
Posts: 2
Registered: ‎01-22-2018
Accepted Solution

LRT224 support WAN selection based on client or IP?

I have a LRT224 for home use, WAN1 is a gig fiber connection, WAN2 is backup hooked to a cable modem.  I love the link failure detection, and failover is working great.  I would love to be able to put some network clients on WAN2 based on their IP (or range).  Can this be done?

Expert
Posts: 13,603
Registered: ‎01-18-2013

Re: LRT224 support WAN selection based on client or IP?


linksysdualwan wrote:

I have a LRT224 for home use, WAN1 is a gig fiber connection, WAN2 is backup hooked to a cable modem.  I love the link failure detection, and failover is working great.  I would love to be able to put some network clients on WAN2 based on their IP (or range).  Can this be done?


Sorry no the LRT are designed for either Load Balancing or Failover. Neither of these qualify as "policy based routing" which is only available on enterprise level routers.


Smiley Wink Please remember to Kudo those that help you.

Linksys
Communities Technical Support
Highlighted
Posts: 2
Registered: ‎01-22-2018

Re: LRT224 support WAN selection based on client or IP?

Thank you very much for that quick reply.