Reply
Posts: 10
Registered: ‎02-05-2017

Power configuration

Need to be able to do automatic scanning of channels and proximity and then turn down the power accordingly, possibly go into site survey mode and allow the user to walk the areas where they expect wireless and then turn the power down accordingly so that you can turn off the lower data throughput modes on the AP. Either automagically configured or allow user to configure.

Posts: 405
Registered: ‎01-07-2012

Re: Power configuration

agreed - due to the density of the nodes, i would love to set the 2.4Ghz radio to 50% and leave the 5Ghz at 100% to encourage propoer disconnects/roaming.

 

Ideally I'd love the Velop to do this auto-magically based on the link speed / quality it can see from the other nodes in the cluster to keep the overlap somwhere around the 60dbm levels.