Reply
Highlighted
Posts: 1
Registered: ‎01-01-2018

VELOP with Linksys router (WRT 1200 AC

I have a cable modem ( NO WIFI ) connected to a Linksys WRT 1200 AC in wired and wifi modes. I also have another router ( with I plan to replace with a VEPOP ) at far end of house, connected via cats 5. What I hope to be able to do is connect two VELOP's, via cat5 to ports on LinkSys router, or switch and operate two VELOP's in Bridge mode connected to current WRT 1200 AC, is this possible?

 

Regards,

Lewis

Expert
Posts: 13,306
Registered: ‎01-18-2013

Re: VELOP with Linksys router (WRT 1200 AC


lewn4co wrote:

I have a cable modem ( NO WIFI ) connected to a Linksys WRT 1200 AC in wired and wifi modes. I also have another router ( with I plan to replace with a VEPOP ) at far end of house, connected via cats 5. What I hope to be able to do is connect two VELOP's, via cat5 to ports on LinkSys router, or switch and operate two VELOP's in Bridge mode connected to current WRT 1200 AC, is this possible?

 

Regards,

Lewis


Yes, I recommend configuring the Velop system in Bridge Mode with the below network topology.

 

Modem => WRT1200AC => Velop (Primary Bridge) => switches => Velop nodes\other devices


Smiley Wink Please remember to Kudo those that help you.

Linksys
Communities Technical Support