Posts: 1
Registered: ‎08-01-2007

Linksys WRT54G Wireless-G Router Not working

I have a Linksys WRT54G Wireless-G Router and it has worked good for a couple months and yesterday it stopped. When I plug it in all the lights are lit even though there arent any ethernet cables connected and the power light blinks constantly. I tried holding the reset button on the back and it didnt help. Anyone know whats wrong or anything I can try to fix it?
Posts: 6,365
Registered: ‎09-16-2006

Re: Linksys WRT54G Wireless-G Router Not working

You need to try again to reset the router to factory defaults.

To reset your router to factory defaults, use the following procedure:

1) Power down all computers, the router, and the modem, and unplug them from the wall.
2) Disconnect all wires from the router.
3) Power up the router and allow it to fully boot (1-2 minutes).
4) Press and hold the reset button for 30 seconds, then release it, then let the router reset and reboot (2-3 minutes).
5) Power down the router.
6) Connect one computer by wire to port 1 on the router (NOT to the internet port).
7) Power up the router and allow it to fully boot (1-2 minutes).
8) Power up the computer (if the computer has a wireless card, make sure it is off).
9) Try to ping the router. To do this, click the "Start" button > All Programs > Accessories > Command Prompt. A black DOS box will appear. Enter the following: "ping" (no quotes), and hit the Enter key. You will see 3 or 4 lines that start either with "Reply from ... " or "Request timed out." If you see "Reply from ...", your computer has found your router.
10) Open your browser and point it to This will take you to your router's login page. Leave the user name blank, and in the password field, enter "admin" (with no quotes). This will take you to your router setup page. Note the version number of your firmware (usually listed near upper right corner of screen). Exit your browser.

If you get this far without problems, try the setup disk (or setup the router manually, if you prefer), and see if you can get your router setup and working.

If you cannot get "Reply from ..." in step 9 above, your router is dead.

If you get a reply in step 9, but cannot complete step 10, then either your router is dead or the firmware is corrupt. In this case, use the Linksys tftp.exe program to try to reload your router with the latest firmware. After reloading the firmware, repeat the above procedure starting with step 1.

If you need additional help, please state your ISP, the make and model of your modem, your router's firmware version, and the results of steps 9 and 10. Also, if you get any error messages, copy them exactly and report back.

Please let me know how things turn out for you.
Posts: 1
Registered: ‎03-23-2016

Re: Linksys WRT54G Wireless-G Router Not working

Please follow these steps -(restart all devices and hard reset the router for 30 sec than restart the router and now open the setup page and type your new SSID and Password and save it . thiw will help for more help contact linksys   . they can help you if there would be any issue with router .