01-12-2018 09:33 AM - edited 01-12-2018 09:36 AM
yes and it was work until firmware 18.104.22.168063 but with latest it is not accessible also there is another box in advanced settings not appear now which is marvell that you can disable Mu mimo or beamforming also you can chose to use streaming through 3X3 only.
01-12-2018 10:22 AM - edited 01-12-2018 10:25 AM
Router has been swapped as of about an hour ago. So far, so good. But prior to this update, it could take a few more hours before anything happened.
Running a WRT3200ACM.
01-12-2018 10:37 AM
Degraded for me after 24hrs.
WRT3200ACM is on the shelf again.
Could you please reset and reinstall this new public build. The timing on your post doesnt add up. I think you may be referring to the Beta not the final build. If you have this final build installed on a reset device and are still seeing degradation that may be another issue, if you can PM me the details I will get it over to engineering.
01-12-2018 10:40 AM
Thanks for the feedback on the advanced wireless section. I have passed it onto engineering as an enhancement. We may need to do a maintenance release shortly after this one to take care of that one, but will keep you posted.
01-12-2018 10:56 AM - edited 01-12-2018 01:48 PM
This Advanced Wireless Settings page has been around since the beginning of Linksys SmartWifi firmware. Traditionally Linksys engineering has always said its unsupported and unmaintained but maybe that will change with Lucas looking into it.
01-12-2018 01:44 PM
I had an uptime of 6 hours before my 5ghz died and no issues with 2.4ghz. Reboot the wrt3200acm to bring 5ghz back from the dead. In Sysinfo.cgi, what should I look for to determine root cause to help Linksys troubleshoot? Thanks.
01-12-2018 02:47 PM
So far this firmware solved my problems.
Unfortunately there still some problems with opensource mwlwifi driver used by LEDE and dd-wrt. With 0x903ffff firmware provided by Marvell on lede it takes too long for some clients to connect to the network. On official 22.214.171.124168 they connect immediately without any problems right now.
Are there any details about what exactly caused problems? Will the fix eventually reach opensource driver?